A flashing light displayed on a vehicle is intended to transmit a specific warning to road users. In order to protect against misuse and to avoid any possible distraction from the meaning of a flashing light, their use and colour are limited to certain types of vehicles and in particular to the circumstances described in the TfNSW VSI 8 Vehicle Standards Information Sheet Flashing lights and sirens. The main positions do not apply to road construction vehicles travelling within 1 km of a construction site if equipped with a flashing yellow light. The brake lights shall remain on while the spring lever is in the neutral position. Machinery that activates the brake lights only when the parking brake is applied are considered non-compliant and are not eligible for conditional registration. For vehicles operated under transport permits or oversized vehicles issued by Transport for NSW, these lamps shall: the braking lamps, if necessary, shall operate when the service brakes are applied. For machinery equipped with a hydrostatic drive system, the brake lights shall operate when the front/rear lever is moved to the neutral position. When reflective tape is applied to the side or rear of a vehicle, the tape shall either extend along the entire length of the vehicle or be mounted on 200 mm tapes. Any conditionally registered vehicle that is larger than 2.5 m or more than 25 m and operates under status codes G05 and/or G093 must have the following: If you require a printed version of these specifications, download the Equipment and Equipment Specifications (RMS Fact Sheet) (PDF 604.07KB).
Learn about the minimum requirements that each piece of equipment and equipment must meet. This label is intended to warn the driver that the vehicle is and must be speed limiting: Any “left-hand drive” or “dual-control steering” sign must: The conspicuous marking tape is not an appropriate replacement for the red and yellow reflective strips. On the dashboard of each vehicle equipped with hydraulic steering, a warning sign “Hydraulic steering system” shall be affixed, which shall also indicate the maximum indicative speed. These vehicles must bear a plate marked “Left Hand Drive”. The label and its wording shall be identical to the reason given below: if the reflective tape is attached to the vehicle in strips:.